Readspeed electronic ignition

[soulsurfer]

That looks a bit scruffy to me

[Elite-225]

Oh dear ! .. Surely this is not British Craftsmanship ? ..

[carlos fandango]

That looks a bit scruffy to me

Me too ?
Thats the single phase one, heres my three phase one.


I had a single phase one first, 2009, then on the way back from IOW my big end went when i stripped it down the stator coils were darker brown and looked burnt ? I took it back to Readspeed and Jerome changed it and gave me a new three phase one.
The CDi on the single phase one was similar to below (not the same one)
http://www.electrexworld.co.uk/acatalog/CD1214.html

Anyway the readings are
Pick up between Brown and White/Black wires 437 Ohm
LT coil between Black/Red and White/black wires 220 ohm

If i were you id speak to Electrex or ring / go to Readspeed ( but make sure you ask to speak to Jerome )
Hope that helps
Russ

[carlos fandango]

Ive just found a pic of my single phase one

[john.t5]

Plate is marked by Electrex alright, have sent them an email with some photos and asked for resistance figures and which replacement CDI is suitable. I take it the 3 phase/8 coil gives you better lights?? Electrics aren't really my strong point

Emailed Jerome too a couple of days ago but no reply as yet...

[firekdp]

PM'd ya.

[Mark ULC]

John did you get the ignition sorted?

[john.t5]

Yes Mark, Shayne has bought a full BGM system - easy fix, lol.