Hi, I've got a spare 200 barrel and head and was thinking of getting it re-bored out to a 225 ! im looking for advice on wheres the best place to get it done ? do i need to get the head altered ? best piston to get ? and approx the cost ?
Tah...
rebores
am a doogal r u a doogal too....!
Your world is an oyster.. springs to mind !! .. but start at the top, try Ralph Saxelby !
- corrado
- Dealer
- Posts: 2588
- Joined: Thu Jan 08, 2009 1:12 am
- Main scooter: Lambretta GP
- Location: Top of Blackpool Tower
- Contact:
Where abouts are you? Makes sense to take it somewhere local to you. The same rebore cost me £45, give them the piston and ask for 3.5 thou clearance after honing. Head will need matching too, you can't use a head smaller than the piston, ie. head 66mm & piston 70mm or piston will hit the head.
AF Rayspeed and MB Developments will both do it.
Ralph could do it, all depends on whether he'll open the door or not, he didn't for me.
AF Rayspeed and MB Developments will both do it.
Ralph could do it, all depends on whether he'll open the door or not, he didn't for me.
I was looking at doing this a while ago with an iron barrel I've got knocking about,everyone will have their own opinion but mine was Mitaka piston from Ron Moss (I've had a couple in various engines and they've been spot on) http://www.supertune.co/index.php?route ... duct_id=53 and maybe one of these to aid the cooling a bit better http://www.supertune.co/index.php?route ... duct_id=78 or one of these from MB http://lambrettaspares.com/spares/bgm-p ... m0384.html and I'd lined up Dan from Scooterotica to do the tuning.Then a mate offered me a race rapido cylinder for £30 and it all went on the back burner
but its still on my to do list.Anyway hope its given you a few ideas.AF Rayspeed charge £30.64 for a rebore http://www.afrayspeed.co.uk/index.php?p ... tributeID=
I am playing all the right notes, but not necessarily in the right order.
