Li/GP floor runners
- vRSG60
- registered user
- Posts: 266
- Joined: Mon Apr 02, 2012 3:56 pm
- Main scooter: Lambretta Li125 Lambretta GP20
- Location: Barrowford, Lancashire
- Contact:
I'm after a set of black floor runners for my series 3 Li. All the black runners on EBay state they are for a GP. Is this because of the colour? GP runners being black and Li runners normally being grey?
I get my kicks out on the floor.
- corrado
- Dealer
- Posts: 2588
- Joined: Thu Jan 08, 2009 1:12 am
- Main scooter: Lambretta GP
- Location: Top of Blackpool Tower
- Contact:
No, GP ones only fit GPs. The only difference is the short outside piece that fits on the legshields. On GP ones there's an extra bit with a hole to accept the sharks tooth screw.
If they're very cheap then they'll be poor quality. Scootrs ones are on a par with Casa [if not better] imo, but they'll be closer to £20, the naff ones are under a tenner.
I might have some S3 ones in Black in stock, I'll check tomorrow.
PM me if interested.
If they're very cheap then they'll be poor quality. Scootrs ones are on a par with Casa [if not better] imo, but they'll be closer to £20, the naff ones are under a tenner.
I might have some S3 ones in Black in stock, I'll check tomorrow.
PM me if interested.
- vRSG60
- registered user
- Posts: 266
- Joined: Mon Apr 02, 2012 3:56 pm
- Main scooter: Lambretta Li125 Lambretta GP20
- Location: Barrowford, Lancashire
- Contact:
Thanks for that. I knew I should have waited. I've ordered a set of S3 Li ones off EBay
Ah well, we'll see, they may be OK.
Ah well, we'll see, they may be OK.
I get my kicks out on the floor.
- vRSG60
- registered user
- Posts: 266
- Joined: Mon Apr 02, 2012 3:56 pm
- Main scooter: Lambretta Li125 Lambretta GP20
- Location: Barrowford, Lancashire
- Contact:
Thanks for that. I knew I should have waited. I've ordered a set of S3 Li ones off EBay
Ah well, we'll see, they may be OK.
Ah well, we'll see, they may be OK.
I get my kicks out on the floor.
