piaggio nrg starting problem
-
- registered user
- Posts: 118
- Joined: Sun Oct 30, 2011 9:36 am
- Main scooter: lambretta s2 li225 ts1
- Location: Spalding,lincolnshire
- Contact:
My sons piaggio nrg 50 is struggling to start.have Cleaned out carb and jets , petrol getting into carb ok. Could it be reedpetals ? Got a good spark. It seems as though it is not getting enough petrol to run . Not wanting to tick over got to keep throttle open to keep bike running :wtf: Any help would be good . ta col
hi, my son in law had the same problem with his piaggio zip, it turned out to be the choke, its got like a wax in it, it heats up and turns choke off once it is running, his had a broken wire to the choke so it would not turn off, fixed wire and it was fine,col68 wrote:My sons piaggio nrg 50 is struggling to start.have Cleaned out carb and jets , petrol getting into carb ok. Could it be reedpetals ? Got a good spark. It seems as though it is not getting enough petrol to run . Not wanting to tick over got to keep throttle open to keep bike running :wtf: Any help would be good . ta col
hope this is of some help to you

check compression .. it may be time for a rebore
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
- registered user
- Posts: 2
- Joined: Mon Feb 13, 2012 1:27 am
- Main scooter: Lambretta GP 150
- Contact:
My gts had a problem where it starts but runs like a traction engine,only thing that cures it is to turn the kill switch off then on again ?
-
- registered user
- Posts: 118
- Joined: Sun Oct 30, 2011 9:36 am
- Main scooter: lambretta s2 li225 ts1
- Location: Spalding,lincolnshire
- Contact:
I have had a new barrel and piston fitted back in september,had a small leak on inlet manifold . my mate that does my lambrettas had it in and it is now running like a dream !! back doing 55 mph again makes you sick that a 50cc moped will do that by only changing main jet and exhaust. :anbrgin;sidewinder wrote:My gts had a problem where it starts but runs like a traction engine,only thing that cures it is to turn the kill switch off then on again ?