TS1225 - 33bhp

[drunkmunkey6969]

TS1 225 - Scooterotica ported cylinder
MB piston
Tassinari V-force Reeds
Franspeed Race Pipe
34mm Delly
6 plate Clutch
Li150 Gearbox 16/47
No welding or crankcase porting.



33.2bhp @ 8100rpm
23.5 ft-lbs @ 6900rpm

Might play with the pipe length on this one and adjust peak BHP up another 250-500rpm, should sit around 35bhp then.

[Darrell Taylor]

well done dan good result
is this the one you put pics up of recently,what stroke/rod is it

[Stokie]

A little cheaper than a Super Monza too I guess?

[Andy Pickering]

Im guessing its the yellow peril ??

[drunkmunkey6969]

Darrell - no, not posted pics of this particular cylinder etc yet.
Stokie - Aye, it worked out a bit cheaper on this project....lol.
Andy - sort of, its a long story....various engines are currently being built, swapped, changed etc....nothing stays the same for too long.

[Muppet]

have you tried the same tune with a smaller carb just out of interest,
muppet,

[drunkmunkey6969]

have you tried the same tune with a smaller carb just out of interest,
muppet,

Not yet, but will try a 30mm phbh eventually.