New Avanti Clubman

[OAP]

New Avanti Clubman
Not 100% ready yet, here is the first one, two days to be spent at the factory this next week to do a few mods and dyno work.
[IMG]

Only fitted this yesterday, will come in three parts, Stub Manifold, Stainless Steel Header pipe, Silencer with adjustable bracket.
Will be giving it a run over the weekend subject to the weather!!! Will perform better than the Mk1
So Scootering Mag bring on a Dyno Shot out.

[bazman]

Had a look at this on Wed at Franspeed , (Andy francis scooters) very impressed with the build quality(as per the norm ), hope to see it in other configurations IE ts1 as thinking along the lines of standard looking ts1 which the exhaust should fit the bill and hopefully perform to suit. Will follow with interest , best of luck.

[soosh]

Looks great,hope this performs well. Got my spanners out ready to fit one,good luck with it Ron.

[Dimitrios_231]

It looks really good,Ron.

[Lambrettatastic]

any ideas on price...roughly.

[mick1]

Are the parts inter-changable with the MK1 pipe? ie can the stainless steel bits be used ?

[OAP]

"any ideas on price...roughly." trying to get it out for £199 retail

"Are the parts inter-changable with the MK1 pipe? ie can the stainless steel bits be used ?"
I'm afraid not Mick

[ArmandTanzarian]

Looks like they'll be out at the same time as the new MB clubman. Typical, you wait ages for a new clubman and two come along at once!

[joespeed]

looks good,is there a stub to fit ts and rb,nice to see a separate stub ,just tried a 'gori' on my rapido whilst on the dyno b-----d of a thing to change, see its all spring/flexy mounted too,,
all good stuff from an experiance scooterist!
regards
joe

[OAP]

Yes we will be doing a TS1, it will be run up on a Dyno using a TS1 next Friday!

Not so sure about the RB though, not much call for them, also would have to make a header pipe to suit.