Can anybody recommend an RB pipe that performs well but is not too fat where an MB rearset is fitted?
Are the Nks any good?
Rear Set brake fouling RB pipe
-
Bufficus
- registered user
- Posts: 271
- Joined: Wed Jan 07, 2009 1:38 pm
- Location: Chelmsford, Essex
- Contact:
Just been putting the finishing touches to my Cut Down. The engine was lifted from my full frame GP. Imagine my horror as I realise the back brake doesn't depress because the Franspeed race is in the way.
Can anybody recommend an RB pipe that performs well but is not too fat where an MB rearset is fitted?
Are the Nks any good?
Can anybody recommend an RB pipe that performs well but is not too fat where an MB rearset is fitted?
Are the Nks any good?
-
wack 63
- registered user
- Posts: 1254
- Joined: Fri Nov 27, 2009 9:33 pm
- Main scooter: '71 GP TS1
- Location: Lincs
- Contact:
You could remove the stop on the pedal and thin the backplate stop,this would allow the pedal to sit higher.Personally I think the pegs on the MB brake are too high even with my short legs so I radically altered mine 