Series 2 Hydraulic Hose
-
soulsurfer
- registered user
- Posts: 2539
- Joined: Thu Jan 08, 2009 2:43 pm
- Location: The Garden Of England
- Contact:
Has anyone run a hydraulic hose through the headset clamp/fork bolt hole on a Series 2?
Turn On, Tune In, Cop out!
-
bigmuff
- registered user
- Posts: 67
- Joined: Sun Feb 13, 2011 1:08 pm
- Main scooter: matt black indian gp
- Contact:
I ran mine down the gap between the clamp and the headset just by the bolt. It then runs over the top of the throttle rod to a hole ground in the bottom headset just below the kinked bit in the headst cover. Sorry not got any photos and cider has impaired my discriptive abilities :fb: :fb:
Yes, just change the headset bolt to a series 3 one.
-
soulsurfer
- registered user
- Posts: 2539
- Joined: Thu Jan 08, 2009 2:43 pm
- Location: The Garden Of England
- Contact:
That's what I was thinking, just wasn't sure as my headset is completely stripped, cheerswrekkah wrote:Yes, just change the headset bolt to a series 3 one.
Turn On, Tune In, Cop out!