Clubman pipes - Again

[joeswoonara]

Armand have you spoken to Ron Moss,very nice helpful man , i picked up a clubman from him at Wickstead last week which he managed to do for me .....i think if you ask him nicely he can convert a standard clubman for you

[Train Driver]

I have a Ralph Saxelby clubman on my RT 255 it works well but Ralph took ages to make it (7 months) and after one 700 mile trip the internal baffles worked loose and rattled around, now being worked on by alan (diablo)
I know Mb have been working on their's for a while and mark said it will be a good performer

[giankx]

Give a look at this:
http://www.mitolambretta.com/product_in ... cts_id=197

Had a 50mm gori on my RT240 with 19,3hp and 20nm of torque.
Only the change of pipe gave me 20hp and 24nm of torque and is really quiet more than a standard clubman!
Pulls really well my sx200 box with 16x46!

Are they stainless and available in the UK?

The manifold is stainless steel, while the pipe is from an original innocenti box and is painted with HT lacquer.
I think they are only available in Italy.

[red ghost]

I kinda like the look of that exhaust, well, except for the dent...

http://www.mitolambretta.com/product_in ... cts_id=197

[lozmondo]

My ancillotti has that so you can clear the cowling bolt.

Not sure if its there from new as I bought mine second hand ?

[crooky]

Got one of the new sloping side af clubman good quality and fit. Its on a stg 4 175 its given me quite a noticeable increase in power over my old indian clubman. Pulls nice and after speaking to af they say it gives a bit extra before it revs out. saying that when I took the old one off the baffles were rattling so not sure its a fair comparison as my old one was well and truly knackered. I was impressed with the quality for a 88 quid pipe

[Train Driver]

Red Ghost
Do boobs rotate the opposite way down under

[giankx]

The dent needs to be there to clear the cowling nut

[mickdale]

Give a look at this:
http://www.mitolambretta.com/product_in ... cts_id=197

Had a 50mm gori on my RT240 with 19,3hp and 20nm of torque.
Only the change of pipe gave me 20hp and 24nm of torque and is really quiet more than a standard clubman!
Pulls really well my sx200 box with 16x46!

dont suppose youve got a dyno for this pipe?
thinking of getting one

[giankx]

This is a comparison between gori racing 50mm and the Stratos Reverse.



As you can see the Mito pipe wins in the complete rev range!

On the road the change was really noticeable too!