1,light switch
2,Igniton switch
3,Rear brake light switch
4,Head light connector block
Intact anything electrical.
Most Wanted Scooter Parts
-
- registered user
- Posts: 202
- Joined: Mon Jan 12, 2009 4:06 pm
- Contact:
A proper 70s Snetterton seat.
and a Lambretta Innovation front disc brake set up that fits both tube and tubeless rimsA proper 70s Snetterton seat.
-----Besa Boga Scooter Alliance-----
-----------Reggio Emilia----------
--------------Italy---------------
http://www.facebook.com/home.php?#/besa ... ef=profile
-----------Reggio Emilia----------
--------------Italy---------------
http://www.facebook.com/home.php?#/besa ... ef=profile
- red
- registered user
- Posts: 637
- Joined: Thu Jan 15, 2009 8:40 pm
- Main scooter: Scomadi TL 250 (Ltd Ed No.3)
- Location: Blyton,Lincolnshire
- Contact:
Fireproof cutdowns
Or anything that I can't break
Would it be too much to ask for parts to fit without the need of fettling.
Thought so



Or anything that I can't break


Would it be too much to ask for parts to fit without the need of fettling.
Thought so


I do not try to explain why I ride Lambrettas,
For those who understand, no explanation is necessary,
For those who don't, no explantion is possible.
For those who understand, no explanation is necessary,
For those who don't, no explantion is possible.
- byron
- registered user
- Posts: 1226
- Joined: Wed Jan 07, 2009 11:45 am
- Main scooter: Li Special; scarred,but sound
- Location: norwich
- Contact:
what everyone should do is send back anything that doesn't fit and demand a replacement that does, or a refund...red wrote:Would it be too much to ask for parts to fit without the need of fettling.
trouble is you order the bits in to do a job, then it's quicker to fettle to fit than have to send stuff back and wait around again... i am guilty of that most weeks...
-
- registered user
- Posts: 151
- Joined: Thu May 20, 2010 10:12 am
- Contact:
mappable direct fuel injection...ha
standing mile: 118.6mph
1/4 mile: 14.04 seconds - 93mph
1/4 mile: 14.04 seconds - 93mph
make that x2Dimitrios_231 wrote:A proper 70s Snetterton seat.
As follows :-
Review of the cooling cowling system, especially the head cowl.
Spare petrol tank that can fit neatly onto the battery tray.
Good side stand.
Internal panel plates that can be glued in to stop the panels splitting. I've seen some homemade ones but anyone making them could make a few quid. Nice profiled SS ones.
Review of the cooling cowling system, especially the head cowl.
Spare petrol tank that can fit neatly onto the battery tray.
Good side stand.
Internal panel plates that can be glued in to stop the panels splitting. I've seen some homemade ones but anyone making them could make a few quid. Nice profiled SS ones.
-
- registered user
- Posts: 214
- Joined: Fri Feb 19, 2010 5:33 pm
- Contact:
for Lambretta`s
1/ 5 speed gearbox capable of handling 20+ bhp and has close ratio`s
2/ oil injection
I`ll not hold my breath
1/ 5 speed gearbox capable of handling 20+ bhp and has close ratio`s
2/ oil injection
I`ll not hold my breath