BGM P200 Cylinder
Fitting a BGM P200 Cylinder to a mates P2 Disc, all going well until I slid the cylinder over the piston and studs the cylinder bottoms out against the electric start flywheel teeth!!! about 5mm short of the engine casing, I had a look on KSC website but it doesn't mention the cylinders won't fit electric start models without modification, so what do I do ? get my mate to send the cylinder back and get a genuine one or do I grind the fin off and mess about til I get it right ?? getting tired of making scooter parts fit now
just grind the fin off .it will be less hassle
grind the fin off. a lot of kits , DR especially, need a fin grinding off to fit. its just that they were designed when vespas didnt have electric start. its not a big job, just be careful with the grinder.
Looks like I will need to grind at least a couple of mm into the transfer port wall to, is their enough meat here without going into the port ?? its not my cylinder so a bit apprehensive
-
H,POOL GADGE
- Posts: 190
- Joined: Sat Mar 21, 2009 7:13 pm
- Main scooter: vespa polini220/gts 300
- Location: HARTLEPOOL
- Contact:
if ye mate does'nt use his electric start! take the ring gear off....don,t panic gadge you won,t go near the port....
Job done, cheers