Can one tell me the position of the ring pegs and whether they would clear the boost port on a TS1 200
many thanks
RB20 Blaster piston
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
-
drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
They dont clear the boost port on an RB20!!davidblythe wrote:Can one tell me the position of the ring pegs and whether they would clear the boost port on a TS1 200
many thanks
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
seriously the ring pegs run in the boost port on the RB20
-
drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
Oh yes.
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
ok is this another benefit of thin wire rings that their inherent flexibilty allows them to spring back and forth when the ring ends are unsupported
-
sean brady scooters
- Dealer
- Posts: 2040
- Joined: Mon Jan 05, 2009 12:09 pm
- Location: Ripon, North Yorkshire
- Contact:
yes dave...............
Sean Brady Scooters - 01765 690 698
-
RinB
- Posts: 317
- Joined: Mon Jan 05, 2009 1:43 pm
- Main scooter: Reflections in Blue
- Location: Grimsby
- Contact:
IMO
Very dubious about rings in ports probability of catching very high
All I can say is make sure youve got a very good clean chamfered edge for them to ride over.
On the RB250 im doing Ive had to go round all ports ensuring chamfers are good as some where not, remenance of Rapido
I know one or two jap bikes have done this but where prone to fail.
All I can say is lets wait and see you never know
Very dubious about rings in ports probability of catching very high
All I can say is make sure youve got a very good clean chamfered edge for them to ride over.
On the RB250 im doing Ive had to go round all ports ensuring chamfers are good as some where not, remenance of Rapido
I know one or two jap bikes have done this but where prone to fail.
All I can say is lets wait and see you never know
If its made of Metal Fettle it !!