JUST BUILDING A RAT CHOP

[RICSPEED]

that triumphs one for the bobber thread on sbw eh joe

[C*NTSPEED]

that triumphs one for the bobber thread on sbw eh joe

yeah id say so mate its a belter
dave hope yer dont mind but ive posted it on to the sbw thread mate

[MADSPEEDRB260]

No mate no problem. well the PRISM TANK it is then thanks...

[MADSPEEDRB260]

Now in this months may edition of B.S.H.

[RICSPEED]

cool ...bsh is worth picking up if only to read ogri

[schniedel]

so,what happend to that then,madness?
have you ever tried a hardtail on a lammy?
is that safe,or do you think the mounts of the engine will crack?

[MADSPEEDRB260]

so,what happend to that then,madness?
have you ever tried a hardtail on a lammy?
is that safe,or do you think the mounts of the engine will crack?

Iv just had loads of engine tuning this month and for the next 4 months so iv had no time mate and yes iv done about 7 hard tail choppers and cutdowns in the past just never took any photo's i'll have to do some more on the old chop when i get chance. iv been doing a very nice series 1 for my self should look ok when i get the time to finish it

[smiffy1968]

I am building a hard tail lammy, big rubber mounts in between the replacemement bar for shock. I have done this mainly because lambretta choppers in my humble opinion look rubbish at the back, with the shock sitting high at the back. I am also not exactly a fan of choppers being tall at the front, i like a longer lower look if you are going to chop it.

[MADSPEEDRB260]

I am building a hard tail lammy, big rubber mounts in between the replacemement bar for shock. I have done this mainly because lambretta choppers in my humble opinion look rubbish at the back, with the shock sitting high at the back. I am also not exactly a fan of choppers being tall at the front, i like a longer lower look if you are going to chop it.

Each to there own. Sounds good you goa any photo's ???

[smiffy1968]

i'll try and stick some on.