Hi all,
I wish to make an 81 link chain but not fit the 'half' link with the clip or cotter pin, but to rivit the link in. Apprently there is such a link around, just not in Australia..
Can anyone suggest a supplier that can help?
Chain Link
-
red ghost
- registered user
- Posts: 545
- Joined: Wed Jan 07, 2009 7:46 pm
- Xbox live gamer tag: Pleasure Master
- Main scooter: lambretta gp150
- Location: Gold Coast Queensland Australia
- Contact:
How come phonetics isn't spelt with an 'f'?
Check out my boobs! <-- <--Just imagine being burried between those puppies!
Check out my boobs! <-- <--Just imagine being burried between those puppies!
-
wack 63
- registered user
- Posts: 1254
- Joined: Fri Nov 27, 2009 9:33 pm
- Main scooter: '71 GP TS1
- Location: Lincs
- Contact:
I have re-used the original pins in the past on tuned motors and never had one come undone.You can push them out with a vice and a small 1/4 inch socket as a sleeve to push it into.Build your chain then tap pin back through and centre punch with a heavy hammer but avoid trapping the links.I've also used the split pin type and again never had any trouble,if they were that bad would shops sell them?