smaller carb for ts1???

[mickdale]

got a 30mm PHBH carb and lth manifold on my ts1

sick to death of getting loads of s***e all over my bodywork

is there a smaller body carb that i can use with a filter/bellows style set up so it doesnt spit fuel/oil everywhere?

cheers
mick

[Muttley McLadd]

Is there something else wrong with it? I run an open 30mil on mine. Admittedly, it's not dry on the inside of the panel. But it's not exactly dripping fuel everywhere.

[mickdale]

Is there something else wrong with it? I run an open 30mil on mine. Admittedly, it's not dry on the inside of the panel. But it's not exactly dripping fuel everywhere.

what main jet you running?

cheers
mick

[corrado]

Jimmers / LTH manifold with Mikuni TMX30 should give you enough clearance to use a breath Sweet filter.

[mickdale]

Jimmers / LTH manifold with Mikuni TMX30 should give you enough clearance to use a breath Sweet filter.

thanks for the info martin

thought so - will be back to jetting again

[corrado]

Jimmers / LTH manifold with Mikuni TMX30 should give you enough clearance to use a breath Sweet filter.

Just remembered that the TMX 32 & 35s are 6mm thinner than the TMX 30. Hence more clearance.

[Diablo]

Mick its throwing fuel out because its overjetted. I've jetted quite a few TS1s with 30mm PHBH and none run anywhere near what your running.

[gaz_powell]

would agree with jetting Ive got two ts1 engines with 34mm dellortos and yes there is some ptrol on panels but nothing like dripping

best of luck

[Train Driver]

I have mentioned them before
http://www.lectronfuelsystems.com/
anyone using one yet