Stock 200 SIL motor
25mm Dellorto PHBL
Casa inlet rubber and K&N (upright)
RScoot exhaust
Main Jet 102
Idle Jet 50
Slide 40
Needle D26 clip 2nd from top
Atomiser AQ264
Air screw 1 1/2 turn out
Seemed to be fine..but went for a blast this morning and when getting to higher revs seems to be holding back a bit and seems a bit choked up after about 40 mph up until then very smooth and responsive.and starts first kick every time..warm or cold...?
Anyone any ideas on jetting maybe main up a bit.
25mm set up.
-
Andy Pickering
- registered user
- Posts: 2172
- Joined: Sun Jan 25, 2009 10:15 pm
- Main scooter: GP
- Location: Hull
- Contact:
Ricspeed, gone but never forgotten RIP my friend #59
-
soulsurfer
- registered user
- Posts: 2539
- Joined: Thu Jan 08, 2009 2:43 pm
- Location: The Garden Of England
- Contact:
Pull the choke on when it holds back and see if it helps. If it does then the main needs to increase.
Turn On, Tune In, Cop out!
-
vespinello
- registered user
- Posts: 19
- Joined: Fri Feb 27, 2009 10:13 am
- Location: Liège - BELGIUM
- Contact:
If the choke don't change the situation (ll say that a bigger jet is needed), try to change the needle
I have read that a D29 needle + AQ 268 are recommanded ....
I have read that a D29 needle + AQ 268 are recommanded ....
From Jupiler Skouter Club