Lambretta Tech

New Topic

11307 topics

Page 171 of 453
- Jump to page:
Previous
1
…
169
170
171
172
173
…
453
Next

Announcements

NEW! Active Topics and Tapatalk (and uploading images)...

Last post by ktmh5
Posted in General Scooter Chat
Replies: 7
by drunkmunkey6969 » Mon Nov 20, 2017 10:48 am » in General Scooter Chat

Two 'help' topics for all users, new and old: Active Topics and Tapatalk.

Active Topics:

Anyone visiting the forum via PC/Laptop etc who wants to...

7 Replies

498860 Views

Last post by ktmh5
Mon Dec 09, 2019 11:39 am
How To Upload Pictures

Last post by Scooterdude
Posted in Welcome
Replies: 19
by drunkmunkey6969 » Wed Mar 27, 2013 10:57 am » in Welcome
1

2
Pictures: Anyone wanting to display pics or vids should use these methods:

Flickr (recommended).
1) Sign up to an account with Flickr:
2) Upload...
19 Replies

769107 Views

Last post by Scooterdude
Tue Aug 21, 2018 4:30 pm

Topics

Imola static timing

Last post by Andy W
Replies: 9
by dopeshots » Wed Jan 01, 2014 7:56 am

Can anyone tell what I should set my timing to on an Imola please?

Cheers :D

9 Replies

4340 Views

Last post by Andy W
Thu Jan 02, 2014 9:17 am
Master cylinder choices?

Last post by hydra
Replies: 16
by Mike - - Bristol » Thu Dec 26, 2013 11:03 pm
1

2
Hi guys , I'm trying to decide between semi and fully hydraulic brakes for my S2 project.
I've seen some neat small master cylinders but not sure...
16 Replies

7007 Views

Last post by hydra
Tue Dec 31, 2013 9:06 pm
piston ring peg

Last post by Tosh
Replies: 4
by Tosh » Mon Dec 30, 2013 3:56 pm

just rebuilding a mates scooter gp200 engine and noticed that the top ring pin is no were near out as far as the bottom ring pin.
what options do I...

4 Replies

2331 Views

Last post by Tosh
Tue Dec 31, 2013 7:39 pm
Original Ducati light flywheel.

Last post by GP Kevo
Replies: 11
by 10 inch Terror » Sun Dec 29, 2013 12:59 am
1

2
Evening all, I have an original Ducati light flywheel in fantastic condition that I'm going to sell. The thing is I don't know what they are worth. I...
11 Replies

3800 Views

Last post by GP Kevo
Tue Dec 31, 2013 11:02 am
Fork Spring Compressor

Last post by nellyboyo
Replies: 6
by nellyboyo » Mon Dec 30, 2013 6:04 pm

I need to get one of these for the shed so .....are they all much the same or are there types to be avoided ?
They do seem to vary a fair bit in...

6 Replies

1941 Views

Last post by nellyboyo
Tue Dec 31, 2013 7:58 am
re made panels?

Last post by weedodger
Replies: 5
by thebassmasta » Mon Dec 30, 2013 12:32 pm

im after a set of sx200 panels, question is has anyone used any of the remade items that are available. i have a set of li panels, not sure if...

5 Replies

2052 Views

Last post by weedodger
Mon Dec 30, 2013 6:09 pm
Early Series 2 Horn Fixings

Last post by PeteB

by PeteB » Mon Dec 30, 2013 5:13 pm

Hi all. My Series 2 has the earlier W shaped folded metal horn bracket (not the later single stud). The current horn is a non-standard one with a...

0 Replies

1710 Views

Last post by PeteB
Mon Dec 30, 2013 5:13 pm
SIP Speedo With Varitronic

Last post by soulsurfer
Replies: 5
by soulsurfer » Sun Dec 29, 2013 6:50 pm

I'm sure it's on here somewhere, but there was a lot to wade through from the early days of everyone trying them out, soI thought I'd ask anyway just...

5 Replies

1909 Views

Last post by soulsurfer
Mon Dec 30, 2013 2:31 pm
glaze busting cylinder

Last post by Tosh
Replies: 4
by Tosh » Sat Dec 28, 2013 7:07 pm

What is the best solution to use with the three legged buster on the cylinder,
i`ve heard of some people using paraffin mixture.

Ta Paul

4 Replies

2237 Views

Last post by Tosh
Sun Dec 29, 2013 6:31 pm
gear swivel home made

Last post by roli-olo
Replies: 20
by martinr » Mon Dec 23, 2013 11:25 pm
1

2

3
made in my shed :D doing the adjuster block next
20 Replies

7822 Views

Last post by roli-olo
Sun Dec 29, 2013 5:51 pm
mtech

Last post by goldeneye
Replies: 3
by BIRDY3263 » Sat Dec 28, 2013 4:19 pm

hi all just fitted mtech unit to my bike all seemed to be good timing wise I have rb20 so set at 23 and you can see it move down when reving to about...

3 Replies

2306 Views

Last post by goldeneye
Sun Dec 29, 2013 1:42 pm
Fuel cap issues.

Last post by GP Kevo
Replies: 13
by Bombay Mix Pilot » Sun Nov 17, 2013 11:20 pm
1

2
Hi All, Just a quick question, Anyone had issues with fuel tank cap seals reacting with current petrol ? I stopped for fuel on Friday, when I removed...
13 Replies

6614 Views

Last post by GP Kevo
Sat Dec 28, 2013 12:32 pm
Lambretta API info

Last post by goldeneye
Replies: 3
by dopeshots » Wed Dec 25, 2013 10:40 pm

I have been told that a Lambretta API LI150 side case is different from all other small block cases.

Does anyone know if this is correct?

Cheers :D

3 Replies

2522 Views

Last post by goldeneye
Thu Dec 26, 2013 1:09 pm
S2 li125 criss-cross Ali runners

Last post by corrado
Replies: 1
by Livi- Graeme » Mon Dec 23, 2013 1:43 pm

Ideas on how to finish these. Polish, paint, powder coat. How have you done yours

1 Replies

1238 Views

Last post by corrado
Wed Dec 25, 2013 6:00 pm
Kickstart oil seal installation problem

Last post by PeteB
Replies: 7
by jazzdude » Sun Dec 22, 2013 12:44 pm

I have been trying for the past hour to get the oil seal in without the inner rubber ring turning inside out when I push the kickstart shaft in the...

7 Replies

2730 Views

Last post by PeteB
Mon Dec 23, 2013 6:46 pm
Crank shortage?

Last post by corrado
Replies: 12
by rosscla » Fri Dec 20, 2013 8:44 pm
1

2
Been looking around at options for cranks for an engine I'm putting together, it does seem that the mid range options available are limited at the...
12 Replies

7301 Views

Last post by corrado
Mon Dec 23, 2013 3:38 pm
poor rear brake performance

Last post by soulsurfer
Replies: 13
by roadrunnerian » Thu Dec 19, 2013 9:15 pm
1

2
i had my rear brake upgraded to a jockeys while it was in for an engine upgrade,now to get the rear brake to stop in a safe distance you have to...
13 Replies

6992 Views

Last post by soulsurfer
Mon Dec 23, 2013 3:27 pm
Tight chain.

Last post by 10 inch Terror
Replies: 5
by 10 inch Terror » Sat Dec 21, 2013 10:08 am

Hi all, I've just fitted an 81 link chain and it is guitar string tight. It is so tight there's probably less than 1mm up and down movement and I...

5 Replies

2262 Views

Last post by 10 inch Terror
Sun Dec 22, 2013 2:32 pm
Targa or BGM or something else?

Last post by jonny wadd
Replies: 6
by Tommy Boy » Sat Dec 21, 2013 12:39 pm

I need new front shocks and have been reading about the Targa line ones with 17 adjustable positions and also heard good stuff about BGM shocks......

6 Replies

3559 Views

Last post by jonny wadd
Sun Dec 22, 2013 2:25 pm
Brake Pedal Splash Plate

Last post by gaz_powell
Replies: 7
by PeteB » Fri Dec 20, 2013 8:59 pm

The clamp-on splash plate for my Series 2 brake pedal has disappeared at the platers (more likely dissolved :lol: ). I can't find replacement ones...

7 Replies

2969 Views

Last post by gaz_powell
Sat Dec 21, 2013 5:48 pm
Leaking sender float

Last post by mcbrid

by mcbrid » Fri Dec 20, 2013 9:44 pm

Hi,

I have a strange problem with the plastic float on my fuel gauge sender unit.

Over a couple of years hidden away inside the tank it has filled...

0 Replies

1658 Views

Last post by mcbrid
Fri Dec 20, 2013 9:44 pm
Standard looking long range fuel tanks

Last post by bizzly
Replies: 22
by watto66 » Mon Jan 21, 2013 11:58 am
1

2

3
Hello All ,

Apologies if this has been covered already on here .

I am thinking of going down the route of running a 25mm dellorto on my GT 186 kit...
22 Replies

13247 Views

Last post by bizzly
Thu Dec 19, 2013 9:13 pm
mugello rings change !

Last post by Donnie
Replies: 6
by scootcoot » Tue Dec 17, 2013 11:54 am

Hey all .. whats the recommended approx miles for when its time to replace piston rings ? im running a mugello 186 with open mouth carb , been...

6 Replies

3156 Views

Last post by Donnie
Thu Dec 19, 2013 11:41 am
My Vega stoped going flat out... Any thoughts?

Last post by cezeta
Replies: 8
by Supereibar » Mon Dec 16, 2013 11:31 am

I took the vega for a spin yesterday. 94 kms (about 60 miles) some flat out on 80km/h (50mph) on the motorway. It was precisely on the motorway by El...

8 Replies

5045 Views

Last post by cezeta
Wed Dec 18, 2013 10:58 pm
lambretta series 2 125 floor runners

Last post by Livi- Graeme
Replies: 8
by yozzer » Sun Dec 15, 2013 10:51 am

I`m after the floor runners for the series 2 125 which are different to the 150/175, everybody sells the 150 runners but the 125 one`s .

8 Replies

3468 Views

Last post by Livi- Graeme
Wed Dec 18, 2013 5:50 pm

New Topic

11307 topics

Page 171 of 453
- Jump to page:
Previous
1
…
169
170
171
172
173
…
453
Next

Return to Board Index

Information

Who is online

Users browsing this forum: No registered users and 2 guests
Forum permissions

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Lambretta Tech

Who is online

Forum permissions

Login • Register

Advertising