Search found 411 matches
I was running 23/65 on early PX125 gears, straight cut primary and clutch, have just dropped to 22/65 straight cut. 23/65 worked well with SIP2 and 24mm flat body carb, cut crank on a ported Malossi 166 the smaller carb and pipe gave it the torque it needed, it didn't do that well up steep hills tho...
- Sun Aug 04, 2019 9:55 pm
- Forum: General Scooter Chat
- Topic: Crikey its quiet in here ..iet in here...in here... here..
- Replies: 79
- Views: 13989
Nice place to break away from FB.
Same problem leaking oil from top seal under dust cover on front PX gas shock. Seen a post on a U.S site that they got theirs regassed, top upped with new oil and resealed at an MTB shop.
- Sun Jun 16, 2019 10:07 pm
- Forum: Lambretta Tech
- Topic: Rocho68 6-plate clutch advice needed
- Replies: 5
- Views: 1409
Got a Rocho clutch in an engine I bought. Not done any mileage on it yet as only recently fitted engine and cabled up, don't know what grade oil is in either but action is fairly stiff, is that to be expected?
Had a chance to test my newly built engine, with ADS3 and 16/46 SX200 which is about 4.5 final ratio...pulls away fine, takes off in fact, pulls from low down in all gears fine...well up to a point in 4th. 4th wont rev about 1/4 throttle so looks like I've overgeared it. Was hoping for nice rounded ...
Slight thread drift - apologies. Corrado...do you know what the port timings on your Muggy are? My set up is very close to yours but not able to pull 4th properly. have Avanti head to fit also once reprofiled for Suzuki piston. Thanks