Was fed up with the people at work giving me the moped/hairdyer treatment & had to prove scoot could do more than 30mph! Took it for a thrash Fri lunchtime with work colleagues following me in their motor (hence the p155 take commentary)
It's a bit of a rat, but I think I proved my point!
(sorry it goes on a bit!!)
Re: Lammy cutdown
Posted: Sat May 01, 2010 6:23 pm
by Treeman
What was your top speed ?
Re: Lammy cutdown
Posted: Sat May 01, 2010 6:28 pm
by sean brady scooters
was it approx 80mph
what engine ,set up do you have ?
Re: Lammy cutdown
Posted: Sat May 01, 2010 6:45 pm
by Cutdown69
clocked at 80mph, but I reckon there was a bit left...theres a slight fuel starvation problem at high revs in top gear.
This is a well used and abused Imola with 28mm Dellorto & Scorpion pipe.
This motor has been running for 6 years, and has clocked up many miles (Holiday in Holland, France et.c) with no filter....I seriously need to change the rings, but these kits seem to be bullet proof!!
Re: Lammy cutdown
Posted: Sat May 01, 2010 6:49 pm
by Skar
LoL Rob, that was a bit quicker than we were going last Saturday on the rideout... See you at Camber if not before.
Re: Lammy cutdown
Posted: Sat May 01, 2010 10:03 pm
by Cutdown69
Yes mate! Hope your clutch is alright by the way
Big up to Mark, who built the top end for me (I took the engine to his place on the bus, in a rucksack!)
Re: Lammy cutdown
Posted: Sun May 02, 2010 12:24 am
by Lazarus
I should say point well proven m8 nice little video as well nice one
Re: Lammy cutdown
Posted: Sun May 02, 2010 12:49 pm
by johnd
well that shut them up!
Re: Lammy cutdown
Posted: Sun May 02, 2010 2:25 pm
by scooterslag
Your workmates seem a right shower of twats, glad you shut them up, nice cutdown chap, any pics of the beast?
Re: Lammy cutdown
Posted: Sun May 02, 2010 4:32 pm
by Cutdown69
Here you go Scooterslag
Cosmetically, it's a rough as a badgers arse, but oh so comfy!
