Scooterotica

Extended exhaust manifold nuts that can be wired up, can anyone share the overall length and wire hole size?

cheers

I use Small frame Vespa 7mm coupling nut that holds on the cylinder shroud from the head

Frank if your making some up can you put me down for a set or two. Not looking for favours, I have cash. Thanks! -Benji

I think they vary depending on the exhaust

vegansydney wrote:Frank if your making some up can you put me down for a set or two. Not looking for favours, I have cash. Thanks! -Benji

Yes I am and I like cash!

Just need length and hole size...

mine are 27mm long and with a 1.5 mm hole but the hole can be bigger

cezeta wrote:mine are 27mm long and with a 1.5 mm hole but the hole can be bigger

And is there a hole on each flat, so 6 in total per nut?

red ghost wrote:

cezeta wrote:mine are 27mm long and with a 1.5 mm hole but the hole can be bigger

And is there a hole on each flat, so 6 in total per nut?

if your safety wiring them you'll only need 2? obviously on opposite faces

mine just have one hole all the way through