can this tune/porting work and is it to recommend to maximise transfer area?
or would it influence the mixture flowing/entrance when transfer are opening as the bottom transfer edge is not there ??
anybody has used it ever ??
Thankx
fishi
can this work ???
Last edited by fishi on Tue Feb 10, 2009 6:22 pm, edited 2 times in total.
- sean brady scooters
- Dealer
- Posts: 2040
- Joined: Mon Jan 05, 2009 12:09 pm
- Location: Ripon, North Yorkshire
- Contact:
tried that link.......still not getting it.........
Sean Brady Scooters - 01765 690 698
f....@@@@k PICASA !!!
sometimes pic can been seen some times not !!!
fishi
sometimes pic can been seen some times not !!!
fishi
- sean brady scooters
- Dealer
- Posts: 2040
- Joined: Mon Jan 05, 2009 12:09 pm
- Location: Ripon, North Yorkshire
- Contact:
sorry guys.......still not getting a pic
are you saying that barrel wall has been removed from whole of transfer port length......?
are you saying that barrel wall has been removed from whole of transfer port length......?
Sean Brady Scooters - 01765 690 698
- drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
Yes Sean ,thats it.
Can you see this pic:
Can you see this pic:
- Attachments
-
- kawa240_3_klein.JPG (23.34 KiB) Viewed 7990 times
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
YES !sean brady scooters wrote:sorry guys.......still not getting a pic
are you saying that barrel wall has been removed from whole of transfer port length......?
- sean brady scooters
- Dealer
- Posts: 2040
- Joined: Mon Jan 05, 2009 12:09 pm
- Location: Ripon, North Yorkshire
- Contact:
cheers dan.........
ooooooh thats a bit extreme.......
having said that......i,m sure the motor will still run.....ok......but i agree that it would be better to have some inner wall left,especially to supply the correct angle of entry of gases into bore...........
ooooooh thats a bit extreme.......
having said that......i,m sure the motor will still run.....ok......but i agree that it would be better to have some inner wall left,especially to supply the correct angle of entry of gases into bore...........
Sean Brady Scooters - 01765 690 698
- drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
Where did you get the pic? What machine is it from?fishi wrote:can this tune/porting work and is it to recommend to maximise transfer area?
or would it influence the mixture flowing/entrance when transfer are opening as the bottom transfer edge is not there ??
anybody has used it ever ??
A normal transfer wall has an 'arc' on the inside to help direct the flow.....so the increased area benefits of the cylinder in the pic maybe outweighed because of this.
Would be interesting to see it on a dyno back-2-back with an identical engine that has a standard spigot.
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos