NK exhaust support bracket

[simplex]

Hi
I've been on the lookout for a bracket to support or hold the end can on an NK exhaust which is currently being held up by the kickstart.. other than trying to find someone to fabricate one from scratch, is there anything already available that will do the job..

Thanks

[sean brady scooters]

sorry mate ,i was too busy watching your avatar....again and again.
what was it you wanted..........

[Andy Pickering]

i was too busy watching your avatar

OMG... ..yep its better than his question.. , dont think Ive seen one available but they certainly need one as it lets down a great exhaust, a couple of mates have had them drop off so might be a fab job fella,,,If you get one sorted you could make a few quid as its a problem for a few..

[Toddy]

Speak to Ben at AFs when i was in there the other week all the new batch of NKs had a rear mounting bracket fitted , this was after oner of my mates end can snapped off on the way to Devon last year he took it in for Ben to weld a rear mount bracket on for him this was the prototype i believe , dont know what they are like as he didnt re fit it on his RB after buying a franspeed in Devon of rich pressley to get him home , there is a lot of stress on the rear end can section of the NKs so the welded mounting bracket may help .

[simplex]

Thanks
Had to drop them a mail instead as no one answers the phone.. see what happens...

I'll probably change the avatar soon, so folk will pay more attention

Thanks

[peter357bikes]

Change the Avatar and I will report you!...er to someone....