Scooterotica

I`m on the look out for a new pipe.

The one I had was very touring/fatboy friendly. Now that I am not a fatboy anymore I (think I) would like a peaky pipe.

The franspeed race looks fave at the mo but does anyone know if they are single walled like the jl race?

Iv`e also looked at the new pm, but I think I would have to loose half of my rear footboard to fit it.

Iv`e had the dev-tour before but stainless doesn`t agree with me.

why not try the pipedesign bullet?

well you have the choice of a nk,jl4,or...and i dont know why not a lot of people shout about it as it works,its tried n tested..the OLD pm..all these are peaky

Stampede wrote:why not try the pipedesign bullet?

That stinger looks on large size. What size is it? I.D.

camel wrote:well you have the choice of a nk,jl4,or...and i dont know why not a lot of people shout about it as it works,its tried n tested..the OLD pm..all these are peaky

Pm`s arn`t very series 2 friendly.

Fux wrote:

camel wrote:well you have the choice of a nk,jl4,or...and i dont know why not a lot of people shout about it as it works,its tried n tested..the OLD pm..all these are peaky

Pm`s arn`t very series 2 friendly.

agreed...i run a series 2 tuned ts1,i run a mild steel dev tour,but ive a modified very old and loud pm for test purposes..i believe the only one you dont have to modify the rear boards and cambridge lambretta jl,s for a series 2....and poss a saigon copy of a pm for a series 2,i know you can get these in mild steel too.

DJB wrote: That stinger looks on large size. What size is it? I.D.

Don´t know, Marc from Pipedesign is producing these exhausts (www.pipedesign.de)

camel wrote:

Fux wrote:

camel wrote:well you have the choice of a nk,jl4,or...and i dont know why not a lot of people shout about it as it works,its tried n tested..the OLD pm..all these are peaky

Pm`s arn`t very series 2 friendly.

agreed...i run a series 2 tuned ts1,i run a mild steel dev tour,but ive a modified very old and loud pm for test purposes..i believe the only one you dont have to modify the rear boards and cambridge lambretta jl,s for a series 2....and poss a saigon copy of a pm for a series 2,i know you can get these in mild steel too.

Modifying the rear boards isnt a problem but I think i almost have to cut the rear footboard in two to fit a pm. Have you got a piccy of it fitted?

Why don't you try this?






It's a Jolly Moto pipe for Ts1.

I've bought one of these but not tried yet. Very well made, jolly moto is number one in Italy for developing 2-stroke racing exhausts.

Chiselspeed have just developed thier own pipes for the TS1 and RBs [might be worth a phone call] and ive been told [not be chiselspeed] they produce better power than the Mamba .