Page 1 of 2
serveta monky bike Pipe
Posted: Fri Dec 18, 2009 11:53 pm
by Lazarus
Hi
Im trying to find out some info about a sports pipe made for a serveta 200 on a monky bike called the Pony.
has any one got any photos of this pipe or know if they would fit a full bodied s3 Lammy
Re: serveta monky bike Pipe
Posted: Sat Dec 19, 2009 12:09 am
by storkfoot
There have been several of these pipes knocking around over the years since Serveta bit the dust. Not sure I've ever seen one actually fitted up. I think they come out the wrong side and would take a fair amount of work to get to fit on a full frame.
I suspect most people have looked at them and thought it would be too much trouble. If you get hold of one, and give it a go, good luck to you
Re: serveta monky bike Pipe
Posted: Sat Dec 19, 2009 12:43 am
by Soulpunk
i think storkfoot is talking about the very late amiga-pipes which the orbar (late serveta) factory ordered from a manufacturer in 1989. theyordered several 100´s but used just ten pipes for their amiga-prototype-scooters (125 / 200).
some 100 of these pipes have been around since then and a big stock got discovered in the middle of the 90s. scooter center cologne and bedlam i think sold these pipes
(without fittings / adaptor).
best would be to contact the lambretta club eibar via the net. they have some ponys and stuff / museum in their club, so they could give you adresses where to get a pipe (nos or used).
Re: serveta monky bike Pipe
Posted: Sat Dec 19, 2009 1:26 am
by carlos fandango
Re: serveta monky bike Pipe
Posted: Sat Dec 19, 2009 12:28 pm
by david
Re: serveta monky bike Pipe
Posted: Sat Dec 19, 2009 2:58 pm
by bristolmod
I like that bike- where can I get one?
South America seems to ring a bell
Chris
Re: serveta monky bike Pipe
Posted: Sat Dec 19, 2009 11:13 pm
by RICSPEED
that one will be the amiga pipe
Re: serveta monky bike Pipe
Posted: Sun Dec 20, 2009 12:04 am
by Stokie
Ricspeed is right the ebay exhaust is the Amiga pipe - I've got one just the same.
They're designed to bolt to the underside of the ag housing so anyone using one would need to fabricate some kind of bracket to secure it or find one of the NOS Amigamag housings that were knocking around a while back.
You'd expect 'Disco Dez' to know what he was talking about - tut tut
Re: serveta monky bike Pipe
Posted: Sun Dec 20, 2009 6:49 am
by red ghost
david wrote:
Me wantee!!!.... That's flippin' sweet!
And how nice would a twin be..
Re: serveta monky bike Pipe
Posted: Sun Dec 20, 2009 1:01 pm
by RICSPEED
there was a home built job in scootering a few years back that was very simerler called a broetta (brown being his surname) he had built it in the seventies and had kept since