Scooterotica

would it be possible if someone could put a piky on of what the franspeed exhaust looks like .THANKS not seen one ,for my rb20

Cant put you a photo up tosh, but they look very simular to the JL3 apart from how they come off the barral faceing back towards the engine, the cone starts about 8inch from the barral, was in kempys the other week and saw the new 48mm clubman with the big bore tailpipe, iam sure ben said somthing about a U bend for the RB, might be worth a look, PS had to make a exhaust stub for my franspeed to get rid of the double O ring seal on the stub, only weak point IMO.

This is a pick of mine rode it back today after andy f rebuilt the engine and fitted it with the rb25

its not a quite pipe as for problems dont know as new today but seems fine.

Teamv, is your pipe the Race or the Tourer?
I think the Tourer looks alot like a JL3 because thats basically what it is, just with a manifold to fit the RB.
Where as the Race was designed specially for the RB.

yes mines the race dont realy know how well it goes yet as runing in and jetted richer than the man him self,so will have to see when got some miles on it.

thanks chaps for the replies/pikey sending off for rb20 next week but it will take me the rest of the year to get the other bits together,jobs on line so i have to be very carefull with the readies

hi
what carb have you fitted ?
i have fitted the 34mm dellorto
engine is rb25.
and was wanting to compare jetting
thanks

Hi i fitted a 35 mikuni, not what i was advised to fit if you no what i mean ,have got the jetting numbers at home but just realy rich at them moment as dont want to damage it just yet.