which lens pattern - CEV or Aprilia ?

[Piatti]

Hi,

which back light lens do I need or order for this type of casting,

CEV or Aprilia ?

Also is there a gasket between the lens and the bulb holder ?

regards

Piatti

[soulsurfer]

I think either will fit, hence the two pairs of holes, I have CEV on mine.
There is a plastic gasket in between.
Hope this helps.

[RICSPEED]

its the corrello (spell check )that wont fit as it is angled at the back

[rog60]

its the corrello (spell check )that wont fit as it is angled at the back

Is that the one with the integral reflector..............

[RICSPEED]

its the corrello (spell check )that wont fit as it is angled at the back

Is that the one with the integral reflector..............

i think they all do dont they?

[soulsurfer]

its the corrello (spell check )that wont fit as it is angled at the back

Is that the one with the integral reflector..............

Yes
Piatti, any use?

[Piatti]

Thanks for all the replies, the actual light housing has two holes on each side so will accept either a CEV or Aprilla type lens.

The angled type is the one which wont fit ( corrello )

I re-used my original reflector which sits in between the light housing and rear light lens, this had
holes directly in the middle which indicated that I needed a CEV type lens.

There is also a rear lens gasket which goes between rear lens and reflector,

I'll post some pics up when i get a minute

cheers

Piatti