Page 1 of 1
Tameni GP crank needs small end shims in an Indian GP 200?
Posted: Sun May 24, 2020 3:30 am
by Davidsquaredson
Hi, I measured the big end float when the crank was on my bench. Was 0.5mm
That is a big end shimmed, yes?
Or no, I need to shim the little end
Sent from my iPhone using Tapatalk
Re: Tameni GP crank needs small end shims in an Indian GP 200?
Posted: Sun May 24, 2020 5:53 am
by garry inglis
One or the other never both
Sent from my SM-G960F using Tapatalk
Re: Tameni GP crank needs small end shims in an Indian GP 200?
Posted: Sun May 24, 2020 3:29 pm
by Davidsquaredson
Yes. It’s why I’m asking if the tameni crank is shimmed on the big end. It does not seem to have a lot of side to side movement, but I hope to hear from someone who knows
Sent from my iPhone using Tapatalk
Re: Tameni GP crank needs small end shims in an Indian GP 200?
Posted: Sun May 24, 2020 5:33 pm
by Muppet
as is no piston shims needed