Bit of a strange one, I have a Buzzetti flywheel puller and it fits an Li Varitronic flywheel I have perfectly. Just bought a GP Varitronic flywheel to go with a new crank and the same flywheel puller doesn’t fit! I’ve tried ‘persuading’ it in a little but I don’t want to bugger it up.
Anyone else had this/know what the answer is?
Sent from my iPad using Tapatalk
Varitronic flywheel thread differences
-
Grumpy225
- registered user
- Posts: 650
- Joined: Sat Nov 24, 2012 7:59 am
- Main scooter: Gori200, rt195, ld150,rb20
- Location: Bakersfield, CA
- Contact:
Sounds like a rolled thread on the new flywheel. If you have a thread file you might be able to carefully clean up the internal thread on the flywheel. At least look them over carefully under a magnifier to spot the problem.
-
Hughieboy
- registered user
- Posts: 83
- Joined: Mon May 25, 2015 8:37 am
- Main scooter: Lambretta Li S2 GT186
- Location: The Shire
- Contact:
Sorry for the late reply, only just seen this.... oddly, although it took a bit of getting going, the new flywheel puller fit! Maybe my old one wasn’t all that good....
