New clutch spider problem

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
boxofbits
registered user
Posts: 168
Joined: Tue May 12, 2009 9:38 pm
Contact:

Tue Jul 02, 2019 11:25 pm

Just fitted a new spider as it was knacked was meant to be the same spider but can't get clutch to engage now, so they must be some slight diffrance in height or something same plates and clutch. Tried slightly thinner top and bottom plate doesn't engage at all. Adjusted cable as much as I can doenst seem to engage. Do I go thicker steels plates or thinner or any other ideas

Mrnice71
registered user
Posts: 81
Joined: Tue Jul 11, 2017 9:41 pm
Main scooter: Lambretta series 3
Contact:

Wed Jul 03, 2019 10:01 pm

Have you put the spiders side by side to see if theres any visible difference ? Are the steel plates free in the new spider ? Also check the spring locating holes , do they line up with pressure plate properly as some dont

boxofbits
registered user
Posts: 168
Joined: Tue May 12, 2009 9:38 pm
Contact:

Sat Jul 13, 2019 9:00 pm

Cheers sorted spider was slightly taller so got it altered and it's fine now

Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: No registered users and 11 guests