problem with a hyrdraulic in-board front disk backplate

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
Davidsquaredson
registered user
Posts: 131
Joined: Sun Jun 10, 2012 11:41 am
Main scooter: Early Eibar Jet 200
Contact:

Mon Feb 11, 2019 5:33 pm

Hi, I recently tried to install this on my stock in-board disk. The axle would not go through. I have 2 axles on hand, 11.97 and 11.99. My stock backplate diameter is 12.09mm. The vietnamese made hydraulic backplate axle hole is 11.89mm. It is powder coated.

Returning it back to the UK vendor from Canada is a pain, and then I dont know if the vendor who never checked the part when they received them, will do it when they send me a replacement. I dont like it when vendors use the customer as their quality control department.

My tendency is to clean out the powder coating and if that is not it, then drill out larger (its not carrying a load at this spot).

Any one else ever run into this issue and did you open the hole up larger?

Thanks
David

  • Information
  • Who is online

    Users browsing this forum: No registered users and 9 guests