Speedo drive
-
- registered user
- Posts: 166
- Joined: Thu Feb 26, 2015 1:29 pm
- Main scooter: Lambretta S3 Li150
- Location: Coventry
- Contact:
I think I know the answer to this question but need clarification. I have just finished building and fitting the front hub to my Li150. I have replaced the plastic speedo drive and worm with a metal set from MB. However, having thought about it I have not put any grease on to the drive. I believe I should have done this. Is it necessary and will I need to take the hub apart again? Really annoying as it went back together and into the forks like a dream.
- garry inglis
- registered user
- Posts: 1298
- Joined: Tue Jul 21, 2015 8:04 pm
- Main scooter: ts1 230 and rb200
- Location: darlington
- Contact:
Just put plenty on the worm itll be fine