Page 1 of 1
Mb or Readspeed springs?
Posted: Mon May 01, 2017 8:30 am
by steve chapman
Fitted a reedspeed 5 plate clutch in my gt200 , and thought it would be a good ide to fit some mb springs at the same time
but find the clutch is heavy er than i would have liked , my question is before i open up the engine again , are the reedspeed ones any lighter ,, or am i wasting my time, regards Steve
Re: Mb of reedspeed springs?
Posted: Mon May 01, 2017 8:03 pm
by B-Race Tuning
Steve, reputable (read both Readspeed and MB) dealer clutches are balanced to work with their springs. Readspeed/ Readspeed, MB/MB. S.
Re: Mb of reedspeed springs?
Posted: Mon May 01, 2017 8:10 pm
by garry inglis
I would bear with the mb springs they do get lighter
Sent from my SM-A320FL using Tapatalk
Re: Mb of reedspeed springs?
Posted: Mon May 01, 2017 9:32 pm
by 10 inch Terror
I fitted MB springs to my Readspeed clutch and it's as light as a feather. I can pull it in with one finger. They should as already stated get slightly softer after some use.
Re: Mb or Readspeed springs?
Posted: Thu May 04, 2017 11:36 pm
by Lamaddict
I did the same, clutch is a bit heavy but not too bad. I know a better cable would be an improvement. Great clutch option for most scoots, please doesn't waste money on the OTT expensive ones and some of them are crap.
Re: Mb or Readspeed springs?
Posted: Tue May 09, 2017 9:22 am
by shocky
7 x 2.25 inch I used to get mine direct from faulkners
Re: Mb or Readspeed springs?
Posted: Tue May 09, 2017 4:48 pm
by shocky
[quote="shocky"][/quote]
Wrong thread