Page 1 of 1
Cylinder Cowl Spacers?
Posted: Tue Dec 06, 2016 12:42 am
by Leo
I might be imagining this but I am sure I have seen some laser cut spacers that go between the mag flange and the cylinder cowl when you fit a longer rod crank?
If they do exist, anyone know who sells them?
Re: Cylinder Cowl Spacers?
Posted: Tue Dec 06, 2016 12:54 am
by Darrell Taylor
i have 5 and 10 mm available
Re: Cylinder Cowl Spacers?
Posted: Tue Dec 06, 2016 11:29 am
by 10 inch Terror
Re: Cylinder Cowl Spacers?
Posted: Tue Dec 06, 2016 5:32 pm
by Darrell Taylor
tidy work 10 inch
first one i did was hand cut then i got fed up of cutting and filing them and sourcing material so have them all water jet cut for my builds £8 -£10 at the material thickness i use ,, similar to an hours pay at minimum/average wage
Re: Cylinder Cowl Spacers?
Posted: Tue Dec 06, 2016 5:58 pm
by 10 inch Terror
Darrell Taylor wrote:
tidy work 10 inch
first one i did was hand cut then i got fed up of cutting and filing them and sourcing material so have them all water jet cut for my builds £8 -£10 at the material thickness i use ,, similar to an hours pay at minimum/average wage
To be honest for that money I'd buy rather than make one. I did try to buy one but couldn't get a reply from the people I asked.
Re: Cylinder Cowl Spacers?
Posted: Wed Dec 07, 2016 1:41 am
by Darrell Taylor
apologies if it was me ??? i do get busy spells and miss some messages
Re: Cylinder Cowl Spacers?
Posted: Wed Dec 07, 2016 8:37 pm
by Leo
Darrell Taylor wrote:apologies if it was me ??? i do get busy spells and miss some messages
Ive just messaged you on Facebook about some spacers
Re: Cylinder Cowl Spacers?
Posted: Thu Dec 08, 2016 2:36 am
by Darrell Taylor
reply sent Leo
Re: Cylinder Cowl Spacers?
Posted: Thu Dec 08, 2016 5:14 pm
by Leo
thanks