alter gp case
Posted: Sat Oct 08, 2016 6:35 pm
is it possible to dremmel off the lug inside the case were the brass clutch bush goes and then use the case for an li150 caseing and clutch 
Scooterotica
The UK's No1 Lambretta & Vespa Scooter Forum.
https://www.scooterotica.org/forum/
alter gp case
Page 1 of 1
Re: alter gp case
Posted: Sat Oct 08, 2016 6:38 pm
by the way this server is not working right it just said unsucesfull post then you do it again and two go up
Re: alter gp case
Posted: Sat Oct 08, 2016 6:48 pm
Yes, looking into it. Cheersgarry inglis wrote:by the way this server is not working right it just said unsucesfull post then you do it again and two go up
Sent from my iPhone using Tapatalk
Re: alter gp case
Posted: Sat Oct 08, 2016 7:27 pm
I'm sure you dont have to cut the lug off,just remove the brass bush.garry inglis wrote:is it possible to dremmel off the lug inside the case were the brass clutch bush goes and then use the case for an li150 caseing and clutch
Re: alter gp case
Posted: Sat Oct 08, 2016 7:40 pm
"I'm sure you dont have to cut the lug off,just remove the brass bush."
+1
+1
Re: alter gp case
Posted: Sun Oct 09, 2016 9:35 am
I believe this is quite a common thing to do and helps the clutch. It's been done on mine.
Re: alter gp case
Posted: Sun Oct 09, 2016 12:20 pm
ive just took my li casing off and looking at were the li clutch small lever sits to the left it would catch on casting but i will just have to wait till the gp casing turns up and i will see whats to do
Re: alter gp case
Posted: Sun Oct 09, 2016 2:54 pm
What not just swap out the LI pressure plate for a GP one? 
Re: alter gp case
Posted: Sun Oct 09, 2016 3:09 pm
another consideration is the kickstart ramp /end plate !