Page 1 of 1

My GP

Posted: Sat May 28, 2016 8:36 pm
by Padge
here are a few pics of my Italian gp125
sorry I aint got many "before" pics but basically, bought a standard 69 gp that had just been imported from Italy, got it on the road then set about the engine and ended up with what's in it now as I wanted to get the engine as I wanted it before I restored it then I wouldn't be messing around with it and damaging any paintwork etc
Tried to use as much of the original bike as possible and anything I replaced I tried to replace with original or "reproduction" Italian parts

stripping down :
Image

starting rebuild :
Image
Image

and finally :
Image
Image
Image
Image

brief engine spec is 186 Imola ultimate (ported and matched) 30mm PHBH, franspeed supertourer, 5 plate clutch, Augusto 7000, mid weight flywheel , sx200 box with 14/46 (5.1 final drive) GPS’d @ 84mph and the only one of my mates that can keep with me is an MB built TS1 230 ! :D

Re: My GP

Posted: Sun May 29, 2016 12:51 am
by paul d
Well done, great result! I like the way you ran the loom under the rear floorboard strut instead of under the petrol tank. Like the colour too.

Re: My GP

Posted: Sun May 29, 2016 7:59 am
by T5-190
Very nice.

Re: My GP

Posted: Sun May 29, 2016 8:48 am
by daniel whiteley
lovely i do like the gp in that colour

Re: My GP

Posted: Sun May 29, 2016 9:23 am
by 10 inch Terror
Very nice, I'm liking that a lot.

Re: My GP

Posted: Mon May 30, 2016 8:57 am
by Toddy
Nice job :D

Re: My GP

Posted: Tue May 31, 2016 12:32 am
by shamrockexpress
Well done on the small block engine..................just goes to show you dont need 240 cc to do 80mph