Only just noticed these holes in my casing. I dont have them on my other one, why are they there and what should I do about them?
Engine case holes
-
- registered user
- Posts: 1447
- Joined: Tue Jun 29, 2010 9:17 pm
- Xbox live gamer tag: No.
- Playstation gamer tag: PLEASE!
- Main scooter: Lambretta LI Imola 185
- Location: Farnborough Hampshire
- Contact:
They are inspection holes so you can check brake shoe wear. You can get the correct rubber bungs from Scooter Restorations if you wish to Bung the holed up.
- EddieStone
- registered user
- Posts: 432
- Joined: Mon Aug 17, 2015 4:13 pm
- Main scooter: Lambretta Li 150
- Contact:
You can, but they can let in a surprising amount of water. Block 'em up with anything, even a bit of gaffa tape over them is better than nothing.
Last edited by EddieStone on Tue May 03, 2016 2:36 pm, edited 1 time in total.
-
- registered user
- Posts: 1447
- Joined: Tue Jun 29, 2010 9:17 pm
- Xbox live gamer tag: No.
- Playstation gamer tag: PLEASE!
- Main scooter: Lambretta LI Imola 185
- Location: Farnborough Hampshire
- Contact:
The bungs I got from SR were really stiff, so I fitted some softer grommets from Halfrauds. I'd personally fit something in there, as stated, a lot of water can get in through them.
Decent stuff still does.Snails wrote:Yeah - should work, and a good excuse for opening a bottle of wine! If only they still came with corks!
win or lose have a booze
- garry inglis
- registered user
- Posts: 1298
- Joined: Tue Jul 21, 2015 8:04 pm
- Main scooter: ts1 230 and rb200
- Location: darlington
- Contact:
why not put a small domed not with two washers that will sort it out