Page 1 of 1
Pipedesign Endcan
Posted: Tue May 03, 2016 4:59 pm
by Cereal GY
I need a new endcan for my pipe. Any suggestions for a replacement?
I've tried TSR, Franspeed and Sterling but no success. The TSR and Franspeed are slightly too narrow for the diameter of the stinger but the studs do line up, and the sterling is a fail on every point.
Re: Pipedesign Endcan
Posted: Tue May 03, 2016 7:59 pm
by mick1
Why not pipedesign ?
PM Tuning ? SIP ?
Re: Pipedesign Endcan
Posted: Wed May 04, 2016 3:58 am
by joylambretta
Re: Pipedesign Endcan
Posted: Wed May 04, 2016 8:14 am
by Minority
Taylor tuning?
Re: Pipedesign Endcan
Posted: Wed May 04, 2016 9:11 pm
by eden
Minority wrote:Taylor tuning?
rode with a guy with one of them last weekend and its deafeningly loud, far too loud!
Re: Pipedesign Endcan
Posted: Thu May 05, 2016 8:17 pm
by grimspeed
LTH have a large selection of end can's all sizes !
24mm - 32mm in 2mm steps !
https://www.lambretta-teile.de/bilder/p ... n-oval.png
Re: Pipedesign Endcan
Posted: Sat May 07, 2016 12:10 pm
by Cereal GY
Thanks for the replies - got sorted now.
