snapped stud
yes ive had 4 break before 16 ft lbs. s**t, don't use them since.
- Architecten
- registered user
- Posts: 106
- Joined: Tue Apr 29, 2014 1:10 pm
- Main scooter: Allwyn Pushpak GP125 (RT200)
- Location: Wirral
- Contact:
Funnily enough I had one go on me last week...
-
- registered user
- Posts: 859
- Joined: Mon Jul 07, 2014 10:34 am
- Main scooter: lambretta li 125
- Location: Tyne and Wear
- Contact:
Was it a full length barrel stud or one of the additional short ones that screw into the barrel rather than the crankcase.
Also, I never use my torque wrench below about 35Nm as it seems very inaccurate. I've snapped a few smaller screws around 15 or 20Nm. Maybe they tend go out of calibration at the lower end?
Also, I never use my torque wrench below about 35Nm as it seems very inaccurate. I've snapped a few smaller screws around 15 or 20Nm. Maybe they tend go out of calibration at the lower end?