Scooterotica

Hi guys, looking at getting a new crankshaft, 60mm stroke 115mm or 116mm con rod.
Any recommendations or bad experiences?
Looking for a smooth running 230 motor so balance would be important and of course reliability in a tuned motor reving to about 8500-9000rpm.

I would recommend Harry at Pro Porting, built me a crank which is superb

did the same for me, 200 quid last year. spot on and a gent to deal with.

Same as above converted my indian crank to a new 110 rod, shimmed big end incuded a small end ina bearing and a pack plate plus his own gaskets for £95 top bloke to deal with

Got a 60 x 116 crank in my TS1 built it about 5 or 6yrs ago, the only piston I could get at the time was a race tour piston from MB, but I believe there may be other choices around now