Page 1 of 1
Lambretta wheel rim PCD and ID
Posted: Sun Jan 24, 2016 4:30 am
by Ilango
Dear Folks,
Has someone measured the rim PCD and the ID of the 2.10 - 10 rim that fits a Lambretta.
My vernier reads 224mm centre - centre between the diagonally located bolts in the brake drum and
200 mm across the landing area where the rim rests on the drum.
Please correct me if the above measurements are wrong.
-Ilango
Re: Lambretta wheel rim PCD and ID
Posted: Wed Jan 27, 2016 4:10 am
by Ilango
Bump...
Not anyone who has measured them at least once?
Re: Lambretta wheel rim PCD and ID
Posted: Wed Jan 27, 2016 8:42 am
by rosscla
Don't doubt your measurements but curious to know why you think it's an issue?
Sent from my iPhone using Tapatalk
Re: Lambretta wheel rim PCD and ID
Posted: Wed Jan 27, 2016 10:44 am
by shocky
I thought the same why but as I might make a tubless rim holder the dimensions might come in usefull
Re: Lambretta wheel rim PCD and ID
Posted: Wed Jan 27, 2016 11:15 am
by Ilango
rosscla wrote:Don't doubt your measurements but curious to know why you think it's an issue?
Thank you very much Rosscla for confirming.
shocky wrote:I thought the same why but as I might make a tubless rim holder the dimensions might come in usefull
Yes Shocky, you are spot on. Just trying to figure out a local solution for a tubeless rim for my Vijai Super. To import one would cost me a bomb considering the money exchange figures and the customs levied on auto parts.