Page 1 of 1
acceptable conrod float in a MEC crank
Posted: Mon Dec 07, 2015 12:05 am
by scooterslag
What's the maximum conrod float in a black webbed MEC crank? Just got one for cheap and it's got 0.9mm of wear, is it still usable? It's going in a standard GP150, cheers Paul
Re: acceptable conrod float in a MEC crank
Posted: Mon Dec 07, 2015 12:34 am
by rosscla
Is it shimmed?
If not, and using piston shims, then the standard crank maximum would be 1.50mm
Re: acceptable conrod float in a MEC crank
Posted: Mon Dec 07, 2015 1:11 am
by scooterslag
It's not shimmed, good to find out it's still usable, cheers for the info, Paul