Page 1 of 1
Drive side gearbox bearing
Posted: Thu Aug 20, 2015 1:08 pm
by dave411
quick question,is this bearing meant to protrude out of the casing? (on the outside)
TA.
Re: Drive side gearbox bearing
Posted: Thu Aug 20, 2015 1:51 pm
by rosscla
most do but usually by less than 1mm
Re: Drive side gearbox bearing
Posted: Thu Aug 20, 2015 2:19 pm
by dave411
That's about it,just seems strange that when you put the retainer on it dosent bolt down flush.
Re: Drive side gearbox bearing
Posted: Thu Aug 20, 2015 2:41 pm
by rosscla
if you bolt it down too hard, then you can bend the plate.