Simple question I think.
Bought a new Franspeed race TS1, I already have one on the RB.
The manifold on the new pipe only has one spring holder / loop.
I'm sure the RB has 2.
Is this correct, do both springs locate on the same spring loop or is only one used on the manifold.
4 springs have been provided, 2 for the end can and I assume 2 for the manifold, so guess 2 go on the one spring loop on the manifold?
Is this correct?
Cheers.
Franspeed race
One loop on the stub two on the exhaust . Yes both go to the one on the stub
Nice one thanks Eden
Loop on the stub goes chain case side.... or rather all mine do.