Scooterotica

A few years ago I bought a hand built pipe from you for a 180 runner. It was the last one you had and I think you found it on a shelf in your workshop from memory. In the tradition of all good projects just getting round to using it!!

Would I need to increase the main jet on the mikuni VM 20mm carb that I am intending to use?

Need to get an end can and think you said one from a sterling pipe would be the best. Is that right?

Nick

Just curious. Why not send a PM as you are already a customer? More likely to get a timely reply than relying on the man reading a post in the Automatics section.

Not trying to be picky just stating the logical?