Page 1 of 1
thread pitch
Posted: Sun May 17, 2015 5:06 pm
by dave wheeler
m7 thread pitch used on lambretta end plates, inlet studs ect and does anyone know the size and thread pitch of the speedo drive on the hub end?
cheers
Re: thread pitch
Posted: Sun May 17, 2015 5:20 pm
by Donnie
end plate stud should be M7 x 28mm long, 10mm thread each end and 1mm pitch.
Re: thread pitch
Posted: Sun May 17, 2015 5:22 pm
by Donnie
As for speedo I *think* it's M14 with a 1.5 pitch but not sure on that one as i don't have a speedo. Hopefully someone else can check for you on that one.
Re: thread pitch
Posted: Sun May 17, 2015 5:40 pm
by dave wheeler
cheers min