Page 1 of 1
Head not fitting
Posted: Sun May 03, 2015 10:14 pm
by lambro
Following on from the spring posting.
This was dragged in a couple years ago, chap fitted his own top end but couldn't get the head to fit:
These are are the type of scooterists I deal with in work, the ones that need a tad more experience, and a lifetime ban from spanners
Re: Head not fitting
Posted: Sun May 03, 2015 10:17 pm
by B-Race Tuning
Get on. you could do a spigoted head with that, Squish might be 40mm but hey.....
Re: Head not fitting
Posted: Sun May 03, 2015 10:23 pm
by lambro
B-Race Tuning wrote:Get on. you could do a spigoted head with that, Squish might be 40mm but hey.....
I did think on that Simon, but it was the plug length that had me baffled
Re: Head not fitting
Posted: Sun May 03, 2015 10:39 pm
by Yanker
Bit of porting and polishing on the 4T head requred: should be a monster!
Re: Head not fitting
Posted: Sun May 03, 2015 11:22 pm
by B-Race Tuning
lambro wrote:B-Race Tuning wrote:Get on. you could do a spigoted head with that, Squish might be 40mm but hey.....
I did think on that Simon, but it was the plug length that had me baffled
Not sure I know of a 70mm reach plug either
Re: Head not fitting
Posted: Mon May 04, 2015 6:18 am
by mick1
does the water taste strange around where you live ?
Re: Head not fitting
Posted: Mon May 04, 2015 7:30 am
by Spanish Fly
...barrel of laughs......
SF
Re: Head not fitting
Posted: Mon May 04, 2015 10:48 pm
by Ginch
Good thing they have that spring there to hold it on tight!
Re: Head not fitting
Posted: Mon May 04, 2015 10:50 pm
by lambro
mick1 wrote:does the water taste strange around where you live ?
Funnily enough the Bristol channel does have a perculiar taste
Re: Head not fitting
Posted: Mon May 04, 2015 11:19 pm
by B-Race Tuning
'Ere, is that not the new ethanol friendly V.L.C. Kit?
