Scooterotica

your thoughts please , after a gearbox bearing failure i had to change the crownwheel
so opted for an MB version it takes 6 clutch plates and teamed it with a Foxhat extended spider,so now it`s all built up and amazingly i have No drag and No slip .........but there is No "feel " either !! Tried both MB and CamLam springs (they look identical)
Any ideas ??
it`s a TS1 240 5 speed Cyclone

It could be springs, I've got some EBC ones I've used for years that seem to work well and no complaints so far. I've used them with many configurations inc mb/foxhat, rocho clutch and std clutches up to 38 hp

They can be supplied for £15 delivered

I have the same set up on one of my bikes. Fox hat spider /MBD crown wheel. It likes to be on or off and not much in between.

It's a great set up for sprinting (which is what this one is for). Not so sure I would be happy on the street with it.