Scooterotica

Im building a new T5 motor.
60mm bell Crank with 115 blade rod from Mito . 65mm bore polaris piston .
130 / 190 port timings.
I feel that with the long stroke the charictoristics of this engine will
be more akin to a high end P2 Malossi .
So im looking for a pipe to suit .
I was thinking
https://www.scooter-and-service.de/larg ... e-curley-s
or
http://www.microsofttranslator.com/bv.a ... r-220.html
Any thoughts ?
I know I would have to change the stubs but that's not a problem !

Hi

Send a mail to Marco at Pipedesign and tell him the setup of your engine.
-he'll revert with what pipe that suits your engine best...

I've done that several times with very good result!

Ø

is that crank off the shelf as im on the look out for a good race crank

Its a 60mm mazza bell crank with a different big end pin different rod and spacers !
http://www.wasp-performance.co.uk/onlin ... X200E.html
http://www.mitolambretta.com/product_in ... cts_id=274
And a big end pin from Martin Cook at Chiselspeed !