Im buildng a motor BGM 225 motor running a dellorto 30mm carb with a JL full race pipe,
Have any of you got the same set up as im looking for carb settings and Jet sizes.
Hope you can help guys
BGM225 carb set up
-
- registered user
- Posts: 14
- Joined: Mon Sep 23, 2013 9:59 am
- Main scooter: Serveta jet 200
- Contact:
-
- registered user
- Posts: 14
- Joined: Mon Sep 23, 2013 9:59 am
- Main scooter: Serveta jet 200
- Contact:
I looked on the MB site but they give two or three options for each jet and needle etc.
I was hoping some one might have the same set up so I had a starting point.
I was hoping some one might have the same set up so I had a starting point.
-
- registered user
- Posts: 4823
- Joined: Tue Oct 25, 2011 9:50 pm
- Main scooter: Lambretta
- Location: Lanarkshire
- Contact:
Start at the higher end of the ranges in the MB advice and work down till you get it right. Better rich than lean
"Our dilemma is that we hate change and love it at the same time; what we really want is for things to remain the same but get better."
- ForemanBob
- registered user
- Posts: 224
- Joined: Thu Sep 17, 2009 7:27 pm
- Main scooter: GP RT230
- Location: Isle of Naboombu
- Contact:
60mm crank, PHBH 30mm with Breathsweet Filter, JL3 Curly exhaust.
70 Choke
55 Pilot
40 Slide
X7 Needle clip at 3 (to richen up 1/4 throttle)
AV264 Atomiser
122 main (on the rich side)
70 Choke
55 Pilot
40 Slide
X7 Needle clip at 3 (to richen up 1/4 throttle)
AV264 Atomiser
122 main (on the rich side)