Tall 5 plate clutch center spider

[shocky]

http://beedspeed.com/lambretta-clutch-c ... -8172.html
How much taller are they and dont they lift the driven plate out of the sprocket ?
Also wont they make the driven plate touch the kickstart ?

[10 inch Terror]

Also wont they make the driven plate touch the kickstart ?

Yes they do. I purchased one ages ago and ended up binning it. It's hard enough fitting a standard clutch in without it rubbing, let alone an extended one. If you want to go down the 5 plate route, get the Readspeed 5 plate kit. I've got one in my 20 bhp Imola and its spot on. At under £50 they are brilliant value for money.

[shocky]

Also wont they make the driven plate touch the kickstart ?

Yes they do. I purchased one ages ago and ended up binning it. It's hard enough fitting a standard clutch in without it rubbing, let alone an extended one. If you want to go down the 5 plate route, get the Readspeed 5 plate kit. I've got one in my 20 bhp Imola and its spot on. At under £50 they are brilliant value for money.

Yes ive seen them for £38
So whats the point I them

[10 inch Terror]

If I'm to be honest, I'm not sure. They may work with an extra thick side case gasket, as supplied by Cam Lam, but other than that, I'm stumped.....

[shocky]

Also wont they make the driven plate touch the kickstart ?

Yes they do. I purchased one ages ago and ended up binning it. It's hard enough fitting a standard clutch in without it rubbing, let alone an extended one. If you want to go down the 5 plate route, get the Readspeed 5 plate kit. I've got one in my 20 bhp Imola and its spot on. At under £50 they are brilliant value for money.

Do you still have it ill pay postage

[10 inch Terror]

It's living happily inside my Imola motor....

[10 inch Terror]

Unless you mean the spider? That's currently located 20ft under my local land fill site.